Support and News Forum

Hello,

I have XRV 9k 6.0.1 it is running fine, but when i power it down it does not power back on again unless is do a wipe.
Intel VT-x/EPT is on
i noticed that this only happens when there is configuration save on the xrv as without any configuration i can power it off and on with no issues
i have also noticed that when the devices is configured and powered on there is a small clock icon beside the device name instead of the small play triangle icon beside all other up nodes as shown in the below image and when i power it off i get small icon of triangle with a ! inside it instead of the normal stop square icon beside other devices and i can not power the XR on at this point then when i do a wipe the icon beside the powered off is back to normal and i can start the the XR

here is the output of lscpu from cli any clue what does the flags at the bottom means.

Quite simple,

You need to expand config script timeout on lab config ( edit lab )

The timeout must be > than the time needed to load totally all the nodes... ( try value 900 )

You must see all nodes running with a "play" icon before stopping them.

E.

It is amazing how it is simple, thanks for your time man, i will try that tomorrow in the lab.