I'm trying to create a connection from lab to host.
First I Tried to create a connection to the lab to the VM through Cloud9 as show in figure below.
Hardware VM:Default
Host Operating system: Linux Mint 18.3
Virtualizer tool: VMWare player
I though that if i place a IP in the VM interface and other at router interface I could have a comunication, but appears it is not that simple.
If someone could help I appreciate.
Connect lab to host
Moderator: mike
-
- Posts: 7
- Joined: Sat Apr 21, 2018 1:25 am
Connect lab to host
You do not have the required permissions to view the files attached to this post.
-
- Posts: 533
- Joined: Wed Mar 15, 2017 1:54 pm
Re: Connect lab to host
take care with latest mikrotik router....
A bug exist in those image regarding interface ordering....
Use a sniffer to be sure traffic pass trough the right interface
E.
A bug exist in those image regarding interface ordering....
Use a sniffer to be sure traffic pass trough the right interface
E.
-
- Posts: 7
- Joined: Sat Apr 21, 2018 1:25 am
Re: Connect lab to host
Thank You very much.
Like you said, in the image its ether3 but after change change the ip of interface I discovered that to work it should be ether2 while in the mage is port ether3
Like you said, in the image its ether3 but after change change the ip of interface I discovered that to work it should be ether2 while in the mage is port ether3
-
- Posts: 7
- Joined: Sat Apr 21, 2018 1:25 am
Re: Connect lab to host
OK, now I have comunnication between eve-ng and VM , and I have comunnication between VM and Host;
But I don`t have comunnication between the eve-ng and the Host.
I already have enabled ip forwarding on the Guest.
So I can ping the VM ip from the router but not to the Host
But I don`t have comunnication between the eve-ng and the Host.
I already have enabled ip forwarding on the Guest.
So I can ping the VM ip from the router but not to the Host
-
- Posts: 7
- Joined: Sat Apr 21, 2018 1:25 am
Re: Connect lab to host
The image below will show the situation explained.
You do not have the required permissions to view the files attached to this post.