Hello all,
I have added a NXOS9k Image into Eve-NG however when I try to start it, it automatically stops.
I've followed this guide:
http://www.eve-ng.net/documentation/how ... x9k-switch
However I'm stuck at the first boot setup section as the problem will not let me proceed.
Image used: nxosv.9.2.2
Any help would be appreciated.
NXOS9k Switching off after I switch it on
Moderator: mike
-
- Posts: 5080
- Joined: Wed Mar 15, 2017 4:44 pm
- Location: London
- Contact:
Re: NXOS9k Switching off after I switch it on
your EVE must have Intel VT-X option must be ON !!
rewatch EVE install video how to enable it...
http://www.eve-ng.net/documentation/ins ... ne-install
rewatch EVE install video how to enable it...
http://www.eve-ng.net/documentation/ins ... ne-install
-
- Posts: 8
- Joined: Mon Nov 26, 2018 10:35 am
Re: NXOS9k Switching off after I switch it on
Hello Uldis,Uldis (UD) wrote: ↑Thu Nov 29, 2018 1:43 amyour EVE must have Intel VT-X option must be ON !!
rewatch EVE install video how to enable it...
http://www.eve-ng.net/documentation/ins ... ne-install
I've followed your tutorial however out of the three methods to enable the hardware virtualization option, I can only use the VMWare Web Client, Which doesn't let me tick that option (Option greyed out).
Do you know why this could be?
-
- Posts: 5080
- Joined: Wed Mar 15, 2017 4:44 pm
- Location: London
- Contact:
Re: NXOS9k Switching off after I switch it on
if it is greyed out, then Virtualization probably is not evnabled in the BIOS... !!
That need t check for sure..
Then web client will be able to set it ON.
That need t check for sure..
Then web client will be able to set it ON.
You do not have the required permissions to view the files attached to this post.
-
- Posts: 8
- Joined: Mon Nov 26, 2018 10:35 am
Re: NXOS9k Switching off after I switch it on
Thanks for the Reply Uldis!
Got it working now, thank you!
Got it working now, thank you!