CSR1000v sub-interface problems

[steak]

Hello,
I have created a LAB in eve-ng pro (2.0.4-98) with a CSR1000v running Denali 16.03.07. Router boots fine, but cannot communicate over sub-interfaces unless they are set to native. I have spun up four additional routers, each running a different QEMU NIC (e1000, e1000-82545em, virtio-net-pci, vmxnet3, tpl-vmxnet3) but the results are all the same. Deployed from EVE-NG OVA to vSphere 6.5. Appliance adapters are set to VMXNET3.


Behavior sounds very similar to the problem described in the thread below, but i have not yet taken a capture to confirm.
https://community.cisco.com/t5/switchin ... -p/2814674


Any ideas?

[Uldis (UD)]

No Issues in EVE pro with it.

You must create image per our how to, install it from ISO !!!
http://www.eve-ng.net/documentation/how ... li-routers
Denali and Everest has special template.

only vmxnet3 (tpl) or vmxnet3 is right. It does support dot1q.
Your issue could be improperly created image for EVE

I have all versions, Denali, Everest and Fuji working. All images created from ISO.

[steak]

Thank you for that info!

After deleting the network bridge and recreating it seems to be working with NICs set to VMXNET3.

[Uldis (UD)]

for sure, if you change NIC on node bridge must be reconnected !
Or as you did delete connection between nodes, set right NIC (vmxnet3) and connect nodes
Thats correct