Support and News Forum

I am not entirely sure if this is an EVE-NG problem or a Mikrotik CHR problem but I am noticing that my interfaces sometimes change when shutting down or rebooting the node

I am running Mikrotik CHR 6.40

For example if I connect eht1 router A to eth2 router B after a reboot of the nodes or tunr all nodes off and the connection inside the routers might have changed to eth10 on router B.

Did you solve this issie? I'm new to Eve-NG and have the same issue here.

get older Mikrotik, as I know v39 was fine

The same for 6.40, 6.42:
It seems this is mikrotik problem - in vmawre it doesn't work too.

https://forum.mikrotik.com/viewtopic.ph ... 05#p676105