Hi all,
So I just saved and closed my lab down and built a smaller lab but when I start up the devices the console sessions are still from the previous lab i was using that is powered off
Any ideas
Thanks
Anthony
New lab connecting to another lab console session?
Moderator: mike
-
- Posts: 17
- Joined: Fri Nov 16, 2018 1:48 pm
-
- Posts: 5084
- Joined: Wed Mar 15, 2017 4:44 pm
- Location: London
- Contact:
Re: New lab connecting to another lab console session?
before start new lab use wipe nodes
right click on node wipe
and then start
if still you will see previous configs, it is your image fault..you are using saved cfg image...
right click on node wipe
and then start
if still you will see previous configs, it is your image fault..you are using saved cfg image...