How to switch webui from legacy mode
Posted: Fri May 17, 2024 2:41 pm
Hi
I need help in changing the webui from legacy to the native one. The eve-ng is installed on Proxmox with a public IP address. I am not the one who installed but I think the one who did the installation may have made some mistakes during installation. Please, see attachment.
The version is :
dpkg -l eve-ng
Desired=Unknown/Install/Remove/Purge/Hold
| Status=Not/Inst/Conf-files/Unpacked/halF-conf/Half-inst/trig-aWait/Trig-pend
|/ Err?=(none)/Reinst-required (Status,Err: uppercase=bad)
||/ Name Version Architecture Description
+++-==============-============-============-==============================================
ii eve-ng 6.0.1-12 amd64 A new generation software for networking labs.
I have googled but can't find a solution. Does it have to be installed from scratch again to is there a way to change this? I need to add other 5 users so we can run some labs.
Thanks in advance.
I need help in changing the webui from legacy to the native one. The eve-ng is installed on Proxmox with a public IP address. I am not the one who installed but I think the one who did the installation may have made some mistakes during installation. Please, see attachment.
The version is :
dpkg -l eve-ng
Desired=Unknown/Install/Remove/Purge/Hold
| Status=Not/Inst/Conf-files/Unpacked/halF-conf/Half-inst/trig-aWait/Trig-pend
|/ Err?=(none)/Reinst-required (Status,Err: uppercase=bad)
||/ Name Version Architecture Description
+++-==============-============-============-==============================================
ii eve-ng 6.0.1-12 amd64 A new generation software for networking labs.
I have googled but can't find a solution. Does it have to be installed from scratch again to is there a way to change this? I need to add other 5 users so we can run some labs.
Thanks in advance.