Page 1 of 1
Cisco FirePower Management Center Install
Posted: Wed Jul 19, 2017 2:35 am
by dgoodson
I attempted to install Cisco Firepower Management Center 6.2.0 on a bare metal setup. The setup is fine and working without issues. The HW was Intel Xeon 18C / 64GB RAM / 500GB SSD with 6x 1GEb ethernet interfaces. When I boot the FMCv I get the following (See screenshot attached) I have followed the instructions carefully and even attempted to build the bare metal setup 3x times. I have also followed the instructions for fixing the permissions given in the FAQ. Please help. If you cannot see the screen capture, the boot goes directly to iPXE boot up and eventually says "no bootdisk"
Re: Cisco FirePower Management Center Install
Posted: Wed Jul 19, 2017 6:43 am
by ecze
image not seen by emulaor...
image naming probably wrong...
E.
Re: Cisco FirePower Management Center Install
Posted: Thu Jul 20, 2017 7:17 pm
by dgoodson
Ah ha, found the issue. The naming was indeed incorrect and the directions in the tutorial are incorrect! I have it running no issues now.
Re: Cisco FirePower Management Center Install
Posted: Tue Aug 08, 2017 3:44 pm
by book
Hi,
I see the same behavior in my case. I proceed with this guide
http://eve-ng.net/index.php/documentati ... images-set
So, what should be the name of that image? Just hda.qcow (like in above link) or somehow another?
Re: Cisco FirePower Management Center Install
Posted: Tue Aug 08, 2017 4:18 pm
by ecze
mv Cisco_Firepower_Management_Center_Virtual-6.2.0-362.qcow2 /opt/unetlab/addons/qemu/firepower6-FMC-6.2.0-362/hda.qcow
sould be
mv Cisco_Firepower_Management_Center_Virtual-6.2.0-362.qcow2 /opt/unetlab/addons/qemu/firepower6-FMC-6.2.0-362/hda.qcow2
E.
PS: Howto is correct now...
Re: Cisco FirePower Management Center Install
Posted: Wed Aug 09, 2017 3:30 pm
by book
I did.
Also, the folder name for FTD is incorrect. Now it indicates for FMC.