Support and News Forum

Hi Anyone,

Can I please know whether anyone has successfully tested and found/known to be working for "dot1q-tunnel"?

I am trying to find out whether the below works on vIOS L2 image. It is configurable.

If it is known to be working, can you please share a working configuration.

SW3#sho ver | in vios_l2-ADVENTER
Cisco IOS Software, vios_l2 Software (vios_l2-ADVENTERPRISEK9-M), Version 15.2(CML_NIGHTLY_20150414)FLO_DSGS7, EARLY DEPLOYMENT DEVELOPMENT BUILD, synced to DSGS_PI5_POSTCOLLAPSE_TEAM_TRACK_CLONE
SW3#sho runn int g0/0
Building configuration...

Current configuration : 112 bytes
!
interface GigabitEthernet0/0
switchport access vlan 300
switchport mode dot1q-tunnel
negotiation auto
end

SW3#

Mathew

Yes fully supported but find proper vIOS L2 image
viosl2-adventerpriseK9-M_152_May_2018

this one does it

Hi,

Thanks. I will double check the image and look for that one.

Mathew