%PLATFORM-2-SIGNATURE_FAILED on IOL/IOU Image
Posted: Wed Jun 17, 2020 7:00 am
Hi Community,
I have a question here. I have built a lab with 10x switches. So IOL / IOU Image I use the latest i86bi_LinuxL2-AdvEnterpriseK9-M_152_May_2018.bin.
So far so good.
When I start the nodes, several start correctly and with a few nodes the following error message appears when starting:
% PLATFORM-2-SIGNATURE_FAILED: Image '/i86bi_LinuxL2-AdvEnterpriseK9-M_152_May_2018.bin' failed code signing checks, error 'Failure in opening the file'. Ethernet switching has been disabled to protect against attack.
Unfortunately I don't understand why. Why do some nodes start properly and why do others have problems? License file is ok, otherwise all nodes would not start.
If I then add a few more switches, some of them start normally and some have the same error message.
Can someone help me please?
Thank you.
I have a question here. I have built a lab with 10x switches. So IOL / IOU Image I use the latest i86bi_LinuxL2-AdvEnterpriseK9-M_152_May_2018.bin.
So far so good.
When I start the nodes, several start correctly and with a few nodes the following error message appears when starting:
% PLATFORM-2-SIGNATURE_FAILED: Image '/i86bi_LinuxL2-AdvEnterpriseK9-M_152_May_2018.bin' failed code signing checks, error 'Failure in opening the file'. Ethernet switching has been disabled to protect against attack.
Unfortunately I don't understand why. Why do some nodes start properly and why do others have problems? License file is ok, otherwise all nodes would not start.
If I then add a few more switches, some of them start normally and some have the same error message.
Can someone help me please?
Thank you.