Page 1 of 1
Network adaptor
Posted: Thu Apr 12, 2018 11:59 am
by fazlan
i have installed eve-ng on vmware workstation.i have added two network addaptors to eve-ng. but when i enter " ifconfig " it shows only one network adapter has ip address. ( i.e only pnet0 is assigned ip address. pnet1 is not assigned any address ). may i know the reason for it
Re: Network adaptor
Posted: Thu Apr 12, 2018 7:14 pm
by ramindia
fazlan wrote: ↑Thu Apr 12, 2018 11:59 am
i have installed eve-ng on vmware workstation.i have added two network addaptors to eve-ng. but when i enter " ifconfig " it shows only one network adapter has ip address. ( i.e only pnet0 is assigned ip address. pnet1 is not assigned any address ). may i know the reason for it
look at the videos posted in youtube, how to setup 2 interface.
https://www.youtube.com/watch?v=nia7BEQEOHk
R!
Re: Network adaptor
Posted: Sat Apr 14, 2018 2:42 am
by fazlan
yes i did set up 2 interfaces according to the video but it doesnt show up when i enter " ifconfig" . if you are using eve-ng can you pls verify that you can set up 2 interfaces in yours
Re: Network adaptor
Posted: Sat Apr 14, 2018 7:33 am
by Uldis (UD)
you nee dnot set IP on second interface until you have plans use second EVE IP for web GUI access.
By default only one IP must be on EVE, for management only.
Rest interfaces are bridged with external VMnets, so no ip need on it at all.
Subnets on bridged interfaces binds to subnet of VMnat.
UD