Page 1 of 1
sub-interface configuration does not work on cisco assa
Posted: Wed Jan 09, 2019 10:14 am
by dimelo
sub-interface configuration does not work on cisco assa in context multiple mode.
I create the port-chanel then try to create with the sub-interface and it does not work.
some version of img is possible?
thank you all
Re: sub-interface configuration does not work on cisco assa
Posted: Wed Jan 09, 2019 10:39 am
by Uldis (UD)
ASA 9.1.5 does it, and works
Re: sub-interface configuration does not work on cisco assa
Posted: Wed Jan 09, 2019 2:15 pm
by dimelo
oK, Thanks !!!
Re: sub-interface configuration does not work on cisco assa
Posted: Thu Jan 10, 2019 1:44 am
by dimelo
is not working with 9.1..5, it follows below the configuration with the error.
ciscoasa(config)# interface port-channel 1.?
configure mode commands/options:
<1-4294967295> Port-channel interface number
ciscoasa(config)# interface port-channel 1.1
^
ERROR: % Invalid input detected at '^' marker.
ciscoasa(config)#
Re: sub-interface configuration does not work on cisco assa
Posted: Fri Jan 11, 2019 10:03 am
by Uldis (UD)
steps
Create int po
then assign ASA interfaces in the port-channel
and then create po subinterface
Re: sub-interface configuration does not work on cisco assa
Posted: Mon Jan 14, 2019 11:17 am
by dimelo
Ok thanks
I'm working successfully.