Page 1 of 1

The spec of testing vPC with NX9Kv

Posted: Tue Nov 07, 2017 3:05 am
by mirkovic
I've been doing the test vPC(Virtual Port Channel) with NX-OSv9k.
It seems to appear normal with the status of vPC from the result of some show commands.
However the status of port channel presents down with command show vpc and the status of etherchannel from
L3 Switch connecting NX9K Switches is (w).
What I'd like to know is the spec for testing vPC and also other Cisco features regarding Nexus switches.
Thanks

Re: The spec of testing vPC with NX9Kv

Posted: Tue Nov 07, 2017 1:34 pm
by Uldis (UD)
NX9K using different MAC address scheme, so simple IOL, vIOS switches in LACP will not work...
IOL or vIOS SW works only in mode ON..
NXOS to NXOS LACP will work fine
That's it.
It is NX9K image glitch

UD