as i check the cookbook pnet1 ===> connect to cloud 1 ===> virtual adoptor 2 on vmware workastation
i connect the router interface to cloud1 and in VMware create a network on vmnet6 in range of 192.168.249.0/24
but it doesn't work and connection could not be established , do i need to add a route on eve for pnet1
this is all related setting as bellow :
Code: Select all
root@eve-ng:~#
root@eve-ng:~#
root@eve-ng:~# brctl show
bridge name bridge id STP enabled interfaces
pnet0 8000.000c293d6a0c no eth0
pnet1 8000.000c293d6a20 no eth1
vunl0_1_0
pnet2 8000.000c293d6a16 no eth2
pnet3 8000.000000000000 no
pnet4 8000.000000000000 no
pnet5 8000.000000000000 no
pnet6 8000.000000000000 no
pnet7 8000.000000000000 no
pnet8 8000.000000000000 no
pnet9 8000.000000000000 no
vnet0_2 8000.92af0cfe0f6b no vunl0_1_16
root@eve-ng:~#
root@eve-ng:~#
Code: Select all
root@eve-ng:~#
root@eve-ng:~# route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
default 192.168.47.2 0.0.0.0 UG 0 0 0 pnet0
192.168.47.0 * 255.255.255.0 U 0 0 0 pnet0
root@eve-ng:~#
Code: Select all
# The primary network interface
iface eth0 inet manual
auto pnet0
iface pnet0 inet dhcp
bridge_ports eth0
bridge_stp off
# Cloud devices
iface eth1 inet manual
auto pnet1
iface pnet1 inet manual
bridge_ports eth1
bridge_stp off
iface eth2 inet manual
auto pnet2
iface pnet2 inet manual
bridge_ports eth2
bridge_stp off
iface eth3 inet manual
auto pnet3
iface pnet3 inet manual
bridge_ports eth3
bridge_stp off
Code: Select all
root@eve-ng:~#
root@eve-ng:~# ifconfig pnet1
pnet1 Link encap:Ethernet HWaddr 00:0c:29:3d:6a:20
inet6 addr: fe80::20c:29ff:fe3d:6a20/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:5490 errors:0 dropped:2 overruns:0 frame:0
TX packets:14 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:415557 (415.5 KB) TX bytes:1076 (1.0 KB)
root@eve-ng:~#