Cisco Switch/Router Running Configuration

Before posting something, READ the changelog, WATCH the videos, howto and provide following:
Your install is: Bare metal, ESXi, what CPU model, RAM, HD, what EVE version you have, output of the uname -a and any other info that might help us faster.

Moderator: mike

Post Reply
Posts: 1
Joined: Sun Jun 09, 2019 6:59 pm

Cisco Switch/Router Running Configuration

Post by Mostaque » Sun Jun 09, 2019 7:17 pm

I am new at Eve-Ng and using community version. I am trying ti build LAB with cisco ROuter and Switches.
I was able to do it. But once I start a Switch/Router and logged in via telnet on it I can't see the full configuration
on that Router/Switch. Also can't see the full interface list. Lets Say I am cionfiguring Interface Gig 5/1 with an IP
address and I can't see the configuration after using command " Show Running Config". Am I doing anything wrong?? Please help.

Posts: 3
Joined: Wed May 24, 2017 12:39 pm

Re: Cisco Switch/Router Running Configuration

Post by frenky8888 » Mon Jun 17, 2019 11:49 am

This is problem with windows native telent client. Use Putty or SecureCRT instead.

Post Reply